Mews T Perch Mount - made out of iron pipe fittings

[talonsgrip22]

This perch style isn't my idea, but I I did find an easy way to make it out of a few iron pipe fittings. You'll need the following parts. I bought mine at Home Depot:



2) 3.5" black iron floor flanges that have a 3/8" threaded female hole



1) black iron 45 degree elbow - 3/8" male on one end and 1/2" street on the other



1) black iron male threaded nipple (pipe threaded on both ends) - 24" x 1/2"



The mounts will attach to the mews window or wall at a 45 degree angle. The perch will be approximately 18 inches out from it's attached to the wall.



Put them together to look like this:

This link should work this time.

imgur.com/yyhvxp7



You could use a black iron T and some threaded black iron nipples for the perch bar. I had 2x4s handy.

[Falcon Boy]

Links didn't work, would you mind reposting them?

[talonsgrip22]

Hmmm...amazon cloud drive doesn't seem to share so easily. Can you recommend a free picture hosting site?

[Icantmove]

Imgur?

[Falcon Boy]

www.photobucket.com or www.flickr.com/

[talonsgrip22]

Sept 6, 2015 12:14:37 GMT -5 Falcon Boy said:

Links didn't work, would you mind reposting them?

Try this one:


imgur.com/yyhvxp7

[talonsgrip22]

Sept 24, 2015 20:00:51 GMT -5 talonsgrip22 said:

Sept 6, 2015 12:14:37 GMT -5 Falcon Boy said:

Links didn't work, would you mind reposting them?

Try this one:

[Falcon Boy]

Cool, thanks!

[megapode]

I made one like this for a red-tail hawk I was free lofting out of PVC. I liked the PVC pipe because it had some "give" when the hawk jumped to it like a natural branch. It held up for 2years, before I removed it.

[talonsgrip22]

The perches I made are working quite well. I I had to do them again, I'd likely just run a pipe straight to the floor about 18" from each window ledge. Same result, just less complicated.